EZ Motion Controller+ – (Remote Only)

(1 customer review)

$28.56 USD

EZ MOTION CONTROLLER+ (Remote Only). Manually operate or program the EZ Motion Controller+ PIR with this remote control. With large backlit keypad make programming and operation quick and easy. Set brightness, duration, and sensitivity. Turn lights on and off, dim lights manually, set up zones.

The Motion Controller+ factory settings are:

  • Motion Sensitivity – 100% MAX (25’ range at room temperature)
    • Sensitivity is programmable based on desired detection distance
  • Brightness – 60% (Lights turn on at last brightness level lights were at)
  • Duration – 60 min. (Upon activation lights remain on for time selected)
    • Duration is programmable – from 1 minute to 999 minutes
  • Zones – No zone assigned (No zones needed if only using 1 receiver)
    • Zones are programmable – When using more than one receiver it is recommended that each receiver is programmed as a zone

Additional information

Weight 0.3 lbs
Dimensions 4 × 4 × 2 in

1 review for EZ Motion Controller+ – (Remote Only)

  1. WILLIAM JEFFREYS (verified owner)

    Too many buttons and the instructions are not detailed enough.

    • Sophia Powers (store manager)

      Thank you for taking the time to post this. It is extremely helpful, and we will use this information to speed up our improvement on the product.

Only logged in customers who have purchased this product may leave a review.

1 Programmable EZ MOTION CONTROLLER+ PIR Receiver


The EZMOTIONPIRONLY receiver comes with two screws for installation.You must connect the PIR receiver to power from the transformer and then the lights to the receiver.

REMEMBER: Do not mount behind obstructions or plants. Motion detector and light sensor must not be obstructed.

Click here for EZMOTIONCONTROLLER+ Programming/Operation Instructions.

Wiring Guide

Click here for most current information: WARRANTY POLICY.